coal mill - pulveriser lube oil

 
The pulveriser grinds the coal to dust in rotating grinding rollers and sieves, so that it can be used as fuel. The pulveriser lube oil is subjected to extreme levels of very fine particles, and many power plants believe the plant should be shut down periodically to change the oil. But if you keep the oil clean and dry using CJC™ Oil Filtration solutions, then this can be avoided, and your pulveriser lube oil will perform well and have a longer lifetime. 

Challenge
If the pulveriser lube oil systems oil is not kept clean and dry, you risk very expensive repairs or replacements of gears and bearings, down-time and lower output. In addition it is possible that the oil must be changed very often, in some instances every 3-4 months in order for the operation to run - a very costly and unnecessary measure, especially since production is put on hold during the oil change. In terms of servicing the filter, the high volume of particles in the environment pose a risk of high costs for replacing clogged filter inserts too often, if dirt holding capacity is low.

Benefits, installing CJC™ Oil Filters

  • Avoid shut-downs and increase production output 
  • Extend coal mill pulveriser lube oil lifetime 
  • Reduce spare parts consumption by up to 60%
  • Protect your investment
  • Reduce risk of unplanned breakdowns, repairs and maintenance and get piece of mind

Lifetime of the coal mill pulveriser lubrication oil can be extended without endangering the production. When you install a CJC™ Oil Filtration solution on your coal mill pulveriser lube oil systems, you get the oil filter with the highest dirt capacity suitable for the normal service intervals, so that you do not need to service the filter untimely. Technically, CJC™ is known for keeping oil clean, dry and without oxidation residues, which has been documented over many years and in several thousand industrial installations – many of which are in environments with many small particles. CJC™ Oil Filter solutions are installed in many power plants worldwide, and when you choose CJC™ Oil Filters, you ensure a long lifetime of the pulverizer bearings and gears.  And you can even monitor from remote the condition of your system using the Oil Contamination Monitor (OCM).

Your solutions
For coal mill pulveriser lube oil the following CJC™ system solutions apply:

The CJC™ System solutions fit all coal mill pulveriser systems regardless of oil volume, and we can deliver globally where required. In close co-operation with technical organizations, we help select the most fitting solution depending on system type and conditions in the environment. 

Brochures